How to make fingerboard decks better.

After you have a good mold and all follow these steps to make good fingerboards

-Dont use to much glue just enough maybe use a roller of some sort
-spread glue out evenly by using a roller or something
-Leave the deck In the mold for 24Hours
-Put it in the sun or a lamp after you take it out to make it stronger
-When drawing the shape make sure to put it right In where the mold was.
-When sanding use some sort of electric sander or a dremel. makes it easier and better.
-if hand sanding dont press the board to hard it might mess it up
-Drill the holes after you sand
-When drilling try drilling really slow for nice holes that are not torn up.
-take care when doing king pin holes, try make them as neat as posible
-When doing a graphic, if its a sticker,put it on after its shaped, its ifs a burn/engrave/print etc... do it before you mold it.
-Laquering.Laquer at least 4 times and let it dry to the fullest each time also sand a little bit every time until your final coat.

If you do this then your board will have great shape, Great feel, not warped, solid ect....

Any other questions feel free to ask.

Nice dude.

GOOD JOB THAT WOULD PROBBLY HELP SOME PEOPLE THAT DONT KNOW HOW TO MAKE A DECK

Yea Im gonna start Doing it in every single board I make and Actually put time in them.

kingpin holes need to be through two plys

mhm^

Yea That too

yeah made mines better

im m gonna try that when i get venner

I do almost all of these

cool

lenny all you say is cool.

Yea he said cool,yea,ect about 20 times already

really

Denis S. wrote:

Yea he said cool,yea,ect about 20 times already

I know!

lol

Ben same with you.

not really

actually yea really

ok sure well go wit dat

also another thing you should do is after you take it out of the mold let it sit for a couple days.

i took my deck out of the mold and it was my first 4 ply deck i made for fun and wanted to be sure it wouldnt snap so i put it next to a window where the dun was shining and the deck melted i use elmers wood glue wth happened?

fbskater wrote:

i took my deck out of the mold and it was my first 4 ply deck i made for fun and wanted to be sure it wouldnt snap so i put it next to a window where the dun was shining and the deck melted i use elmers wood glue wth happened?

don't put it in the sunlight.... use a lamp... and u prolly didn't let the glue harden enough

im 85% positive that its the glue, i used to use it once i ran out of good wood glue and my deck split once i started to cut it

k